Hello,
We have a DLP6750 PLM device mounted on a DLPCR67EVM daughter card and controlled by a DLPCRC900EVM.
We are currently trying to test the system using the TI GUI, but we have not been able to identify the correct firmware for this hardware configuration.
The firmware originally installed on the board appears to be intended for the DLP670S. We also tried programming the F_Hologram firmware, but neither firmware works with our DLP6750 setup. In both cases, the GUI reports that the controller and DMD are incompatible.
Could you please advise us on the following?
- Which firmware image is required for a DLP6750 PLM used with the DLPCR67EVM and DLPCRC900EVM?
- Is this firmware publicly available? If so, where can it be obtained?
- If it is not publicly available, could you point us to the appropriate contact or provide guidance on how to obtain it?
- Are there any specific hardware, GUI, or configuration requirements for using the DLP6750 PLM with this controller board?
We can provide screenshots of the firmware information and the incompatibility message if helpful.
Thank you for your time.
Hello,
We have a DLP6750 PLM device mounted on a DLPCR67EVM daughter card and controlled by a DLPCRC900EVM.
We are currently trying to test the system using the TI GUI, but we have not been able to identify the correct firmware for this hardware configuration.
The firmware originally installed on the board appears to be intended for the DLP670S. We also tried programming the F_Hologram firmware, but neither firmware works with our DLP6750 setup. In both cases, the GUI reports that the controller and DMD are incompatible.
Could you please advise us on the following?
We can provide screenshots of the firmware information and the incompatibility message if helpful.
Thank you for your time.