Hello,
I am using a Raspberry Pi Pico, and I noticed that the onboard LED is typically referenced as GPIO 25 or board.LED. However, I am unsure if it is fully supported in the current version of the u2if firmware.
Could you please clarify:
Is the onboard LED on GPIO 25 (or board.LED) officially supported for the Pico board?
If so, are there any specific configurations or initialization steps required to enable or use it?
If not currently supported, are there any plans to add support in future releases?
Additionally, this feature is nice to have for testing the basic LED blink script after setting up u2if, as it would allow a quick check that everything is working as expected.
Thank you for your time and assistance!
Hello,
I am using a Raspberry Pi Pico, and I noticed that the onboard LED is typically referenced as GPIO 25 or board.LED. However, I am unsure if it is fully supported in the current version of the u2if firmware.
Could you please clarify:
Additionally, this feature is nice to have for testing the basic LED blink script after setting up
u2if, as it would allow a quick check that everything is working as expected.Thank you for your time and assistance!