Dear parachvte,
Thank you so much for creating a Snapmaker J1 Cura Profile.
There is a raft air gap setting which can be adjusted but as far as I see it does not bear any effect.
The raft is easily removed from the build plate but the part is very difficult to remove from the raft.
The part first layer is damaged.
Could you please explain how to use this setting in Cura?
Regards
PS: The people from Snapmaker tell me the air gap is fixed in Luban on a value of 0,3 and can't be changed.
Dear parachvte,
Thank you so much for creating a Snapmaker J1 Cura Profile.
There is a raft air gap setting which can be adjusted but as far as I see it does not bear any effect.
The raft is easily removed from the build plate but the part is very difficult to remove from the raft.
The part first layer is damaged.
Could you please explain how to use this setting in Cura?
Regards
PS: The people from Snapmaker tell me the air gap is fixed in Luban on a value of 0,3 and can't be changed.