BOM for Classic Composite Edition not correct

[sureal808]

R2 references 120k ohm resistor but links to a 105k resistor. Which is the correct one?

[sureal808]

R1 does not have a link. Should link here: https://www.digikey.ca/en/products/detail/vishay-dale/CRCW08054K70FKEAC/7928553

[nebhead]

Also, the switch listed in the BOM (SW1 | Switch | E-Switch |   | DPDT | EG2215) doesn't seem to have the correct footprint, or it's the wrong switch. At least for the Classic THT DIY edition.

[ShawMerlin]

The switch did change on a few boards and not everything got updated correctly. To make sure we cover all basis, I can add both switches to the BOM. It would have been better if I changed the SW tag so they didn’t match. Thank you for pointing this out.

…

On Monday, April 21, 2025, nebhead ***@***.***> wrote: Also, the switch listed in the BOM (SW1 | Switch | E-Switch | | DPDT | EG2215) doesn't seem to have the correct footprint, or it's the wrong switch. At least for the Classic THT DIY edition. — Reply to this email directly, view it on GitHub <#26 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AQZJHHVCWPY4YR3WGZ7OBED22VEOFAVCNFSM6AAAAAB3LTKKLSVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDQMJZGM3TMNZSGY> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***> *nebhead* left a comment (ShawMerlin/NES-Power-Module-Redesign#26) <#26 (comment)> Also, the switch listed in the BOM (SW1 | Switch | E-Switch | | DPDT | EG2215) doesn't seem to have the correct footprint, or it's the wrong switch. At least for the Classic THT DIY edition. — Reply to this email directly, view it on GitHub <#26 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AQZJHHVCWPY4YR3WGZ7OBED22VEOFAVCNFSM6AAAAAB3LTKKLSVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDQMJZGM3TMNZSGY> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[nebhead]

The switch did change on a few boards and not everything got updated
correctly. To make sure we cover all basis, I can add both switches to the
BOM. It would have been better if I changed the SW tag so they didn’t
match.

Thanks for the super fast response!