Preparation of resubmission for our HardwareX paper

[RobertLRead]

Our HardwareX paper has asked for Major revisions again. Some of their requests can be rejected, but I intend to perform the following work:

• Measure the PID mean, overshoot and variance of the temperature as requested.
• Design an equivalence TOST design
• Register the design with OSF
• Choose an incubator to purchase
• Perform the experiment and report
• Order a new enclosure.
• Design a new Petrifilm holder for the Moonrat dimensions to support 40 samples incubated at the same time.

[ForrestErickson]

@RobertLRead
I intuit that when you measure the PID behavior it will be for a particular heat capacity of the "load", the samples.
Ideally the PID will accommodate a minimal load and maximal load and for response characteristics should be tested for each.

I wonder about simulations. Perhaps some volunteers with simulation experience might be put to good use to build a simulation which can be made to match experimental results. Such a simulation might give insight into the behavior with other thermos bottles and wider ranges of heat capacity than the current thermos affords.

CC: @melanielaporte