Clicky Clack Door buffer 350 wrong length

[astechevolves]

I grabbed the stls from the DoorBuffer > STL > Clicky-Klack > Short Docks > 350 and the left and right side were quite a bit longer (~75mm) than they should have been. Pulling the model file from CAD and printing the parts in the model seem to be correct (still printing). The screen shot below shows the comparison between the two. The longer one is what is in the folder now and shorter one is pulled form the 350, Clicky Clack Model. I just wanted to let you know. thanks for the effort in any case!

[astechevolves]

@Dumplap I forgot to tag you as you would likely be the one to make the swap.

[Dumplap]

I’m in finals week, I can prolly get to this next week or maybe this weekend. These were made for AngusMcLead on Discord reach out to him about how these fit/assemble bc I never put these together or printed them.

If you still need help this weekend feel free to reach out on discord!

[astechevolves]

Honestly there is no help required. I opened the model and saved out the right ones already. I was just putting it up here so whomever needed the information was aware that the STL's in the folder did not match the intent. My door is together and i am being angry at toolhead calibration now. Moving on :)

I do appreciate the reply though. Good luck with finals!

[Dumplap]

I have a few questions about how the STLs didn't align with what you were doing? are you using the chaoticlab hinges? also you wanna dm me on discord instead @Dumplap thx